Surface Preparation
|
N/A
All work surfaces should be clean, dry, and free of dirt, dust, debris, oils, un-adhered coatings, deteriorated membrane and other contaminants that may result in a surface that is not sound or is uneven. If necessary, clean the surface to receive the fl ashing with an approved EPDM membrane cleaner.
|
Safety
|
N/A
Prior to working with this or any product consult product label and Material Safety Data Sheet (MSDS) for necessary health and safety precautions.
|
Limitations
|
N/A
- Not for use on PVC roof membranes.
- Not for use in high traffic areas.
- Talc, dust, oil, ice, snow, or wet conditions inhibit good adhesion. Clean and dry surfaces are necessary for proper installation of this product.
|
Color
|
N/A
Black
|
Packaging & Coverage
|
N/A
Millennium EPDM Flashing Tape is available in the following sizes:
|
Width
|
N/A
6 "152 mm
|
Rolls/Case
|
N/A
2
|
Storage and Shelf Life
|
N/A
Store material in original unopened packaging at temperatures between 40°F-110°F. Shelf life is 9 months when stored as recommended.
|
Applications
|
N/A
- Clean entire surface where Millennium EPDM Flashing Tape will be applied.
- Apply EPDM primer to entire surface to be covered using the supplied scrub pad. NOTE: Use caution when installing at temperatures below 40oF (5oC) to prevent blushing of EPDM primer (formation of condensation on surface of primer).
- Allow the primer to dry to the touch (no material transfer, typically less than 20 minutes). Dry time will vary depending on ambient temperature and humidity.
- Once the primer is dry immediately install Millennium EPDM Flashing Tape.
- Position Flashing Tape over primed area and remove release liner. Press down and form Flashing Tape by hand.
- Roll the flashing with a 2” (5.08cm) wide silicone roller.
- Seal edges of flashing detail with Millennium EPDM Edge Sealant.
|
Technical Data
|
N/A
| Typical Physical Properties and Characteristics |
| |
Typical Values |
Test Method |
| Base Polymer (Flashing & Tape) |
EPDM |
FTIR |
| Color (Flashing & Tape) |
Black |
Visual |
| Tensile Strength (uncured) |
250 psi max. |
ASTM D412 Die C |
|
Benefits
|
N/A
Flashing details with proven peel-n-stick technology Improved safety Long-term durability Saves time and labor Suitable for roofing or waterproofing applications
|
Note
|
N/A
The foregoing information is published as general information only. The listed properties and performance characteristics are typical values and are not to be interpreted as manufacturing specifications.
|
Features
|
N/A
Excellent adhesion and formability Fast installation No torch or liquid adhesives Resistant to UV light, high heat and moisture Waterproof detail
|
Length
|
N/A
100 '30.48 m
|
